Laying Kitchen Floor

We were finally able to start laying the kitchen floor.  Installing it wasn't hard, but the details of floorboards which have minor curve in them or slight planing differences quickly make themselves known.  All in all, we only have a couple of minor hiccups and, in general, the first section went down pretty well.

I bought a tongue and groove router bit set from MCLS:


The details of cutting tongue and groove aren't terribly difficult, but even minor differences in thickness cause some misalignment.  But we worked through those and installed the first row by face nailing along the wall edge.  The first board also needed two holes for HVAC ducts.


After installing the first 7 boards in the sitting area, we stepped back to admire our work:


No comments:

Post a Comment

Garage, other side, part deux

We don't have a ton of pictures even though good progress was made.   Short story: we finished all the termite damage replacement, simil...