Buttoning up a ceiling

Spent most of the day cleaning up bathroom from spray foam insulation and getting ready for drywall.

Had to pull down all plastic sheeting (and dripped foam insulation), seal any leftover small cracks and then install furring strips - this will lower the ceiling about 1/2" and make it easier to go over the spray foam.


Also pictured above, we packed the rest of cavities with old insulation batts that were previously removed from ceiling.  And marked the wall where furring strips are located to make screwing drywall easier.

And then we also installed leftover R13 fiberglass batts between the furring strips to make it clean and offer even more insulation.


And mostly finished - just drywall over batts and mud the corners.





Spray Foam

Finally got a good weather day, so we were able to insulate bathroom ceiling.

Removed all insulation and cleaned



Cover all walls and floor with plastic sheeting.  Because spray foam is messy.


A little PPE for good measure.


Looks almost like popcorn when done.




Yard Work

Took some time this past week to start yard work - some cleanup and planting.

Dug five holes ahead of time to ensure we hit no stumps or other debris.


Bought 5 forsythia at Lowe's


Cut a stump down flush with ground.


Planted 5 fosythia and graded.


Added weed block and water new plants in.


And of course, we found some grubs.  Guess more grub killer is coming.



Snowblower: some assembly required

Start of reassembling things.


Carb and muffler before:


Carb and muffler after replacement:


Inside of pull start before:

Pull start, fuel line, gas tank and top heat shield reassembled after clean/paint:



Snowblower: sand and paint

We're replacing a few key parts (carb, muffler, fuel line, belts) but we're also cleaning, sanding and painting every bolt and piece of hardware.

Muffler cover/housing sanding - rust removal.

Muffler cover/housing after paint:


Snow chute handle and mounting bracket:

Front housing after sanding and rust preventer (black) applied:

Front housing after sand and orange paint  (yes, it's upside down for painting)



Snowblower disassembly

The fun part: ripping it all apart.  And wow is there a lot of rust on this animal.

Pull start - note rust on housing.


Old/new carburetor

Old/new muffler

Remove auger and housing from engine assembly


Remove auger


Front housing has lots of rust



Side trip: snowblower

I have a couple of house things I'd like to move ahead with, but some are waiting on warmer weather. So in the meantime, I've embarked upon a project to overhaul my 16-year-old snowblower. (That's like 80 in people years.)  It runs ok - a little surging, which lead me to replace the carburetor but then I thought "why do one thing when I can do ALL the things?" So here goes...

Current state before: lots of rust, dirt and wear all around.  


Lots of rust inside housing:

Even wheels are a touch rusty:

The source for this entire project: the carburetor. Note rust and dirt, not to mention what you can't see on the inside.



Weekend of little things

Spent the weekend working on lots of little things, trying to keep forward progress.

Stripping and repainting hinges in black:


And reinstalling some cabinet doors

Finish painting third wall in bedroom

And last window now has trim

Bedroom closet has new hinges and doorknob

Thatched lawn:

Quick mow to pickup dead grass/leaves.  And then applied crabgrass preventer.

Garage, other side, part deux

We don't have a ton of pictures even though good progress was made.   Short story: we finished all the termite damage replacement, simil...