WE have ... a dock?

Looking around and talking to neighbors, I realized others have docks or access to pond.  This led to dock-envy so let's go.

After some debate how to get posts in water, we decided to go with PVC pipe fill with concrete.  This seemed better for pond life than immersing arsenic-dowsed wood in pond for years.

Since we're in a drought, we were able to dig with post hole digger directly in pond and drive PVC posts in.  Mix some concrete and fill post.


We pre-drilled holes for bolts before pouring concrete, so securing 2x6 to each post only took a few minutes.


Add some deck board and voila, instant dock.  Now if only the water would come back.



Planing Trim

When  you work with reclaimed wood, you need to clean it up.  That means cut to size and resurface both sides to remove old/dried wood.

We've gotten good use from a Grizzly planer over 3 years, but that luck ended last week.  During routine sharpening of blades a screw became stripped and then wouldn't seat properly.  And when you operate something that spins at 10000 RPM with a screw missing, bad things happen.

The broken metal below is one of the blades and mounting bracket.  The cost to repair this would exceed a new planer, unfortunately.


Sadly, this ended up straight into the trash. :(

But that means we get a new one and we're going with the same model that the rest of the world seems to love: Delta.

Of course it's brand new, but it cuts smooth as butter and has a few features the old Grizzly did not.  So we're back in business after a one week hiatus. 

Milling Sunporch Trim

We need to close out the building permit, and the last thing left is finishing trim in the sunporch.  So we begin to cut and mill reclaimed wood for this purpose.

First we measure all doors/windows and make a list of trim needed.

We then grab all the reclaimed wood, measure and try to fit the existing pieces against the needed trim list.


We quickly cut boards to the desired width and approx length.


We have some other leftover pieces that are too short, so we cut the half lap joints:


And glue them up to make longer trim pieces.


We'll then begin the process of planing all these down to the same thickness.  But the next post will explain the hell that caused.




Outdoor Work

And handful of outside activities moving forward...

Finish shingle over the sunporch.


And add trim on both sides.



Glue up long thin strips of shingles


And apply under windows - often thin shingles split when just nailed individually.  Before:


After:





Let There be Light

So with a lot of investigating, we figured out every wire in the sunporch with the exception of one.

We need to make the existing can light openings larger. So we first attach a 2x4 and find the center of the existing hole.


We use the hole saw for new lights to make the opening an inch larger.


Yeah, drywall is dusty.


Reattach all wire and install the new driver boxes.


Apply ceiling paint before we install fixtures.


And install the fixtures.

We clean up the wiring from this:


To this:


And it's brighter than a runway now.






Garage, other side, part deux

We don't have a ton of pictures even though good progress was made.   Short story: we finished all the termite damage replacement, simil...