Kitchen Floors, 3

 As we get closer to possibly installing kitchen floors, we now begin the process of inventorying each piece of cut/planed flooring and then laying out where they will fit best.  Best, meaning they are used almost in their entirety, and don't leave too many cuts (we don't want to splice together 10 small pieces for any one length).

This is grouping of 8-10 boards salvaged from barn.  The widths vary a little in this group from 9" to 11"

This is the collection of boards salvaged from original floor.  These are all cut to same width, approx 12 1/4"

These are the super wide original floorboards - we have three that are between 19" and 20" wide.  Due to their excessive width, we have to plane these with a small electric hand planer.  The small pile of 4 board on left are last boards from barn yet to be cut/planed:

From the three groups above, I built an inventory of each board and assigned a unique letter to each:

12 3/16 width:

*A 69.5”
*B 65”
*C 50”
*D 164”
*E 136”
*F 128”
*G 127”
*H 90”
*I 85”
*J 77”
*K 82”
*L 68”
*M 132” 5/8” thick
*N 138”
*O 138”
*P 136”
*Q 155”

Others
*T 126” x 10.25”
*U 128” x 9”
*V 128” x 10.25”
*W1 128” x 11”
*W2 128” x 11”
*W3 128” x 11”
*W4 128” x 11”
*X 110” x 9.5”
*Y 81” x 9.125”
*Z 68” x 10.25”

Oversized (widths
AA 128" x 19"
BB 127" x 19"
CC 129" x 20"

I sat down in did a scale drawing of the kitchen (down to an inch or so) in LibreCAD and then began the layout of boards.  From what I was able to piece together, I need about 4 more boards - hence the 4 above that need to be cut/planed.



No comments:

Post a Comment

Garage, other side, part deux

We don't have a ton of pictures even though good progress was made.   Short story: we finished all the termite damage replacement, simil...