Shingles, anyone?

After shingling the entire house 2 years ago, it was good to take a break. But shingling can be fun, so we're back at it with the garage and leftover shingles.

This wall is super short and quick to complete.


Working up a roof pitch is always fun (and slow).


But once trim is applied, it's a lot cleaner.


We round the corner, and also apply window trim.



Termites and water damage has to go.

So both from termites and water damage (due to lack of gutters) we need to clean up a lot of the bottom plates.

First remove exterior siding:


Not shown: use a column to support the load on this wall.  Then cut out the damaged section of studs:


Remove the bottom plate, replace section with pressure treated lumber and splice all studs:


Add new sheathing and Tyvek on exterior and voila - ready for shingles:




Garage Siding

The siding on the garage needs to be improved, and likewise we need to address the termite and rot for some of the studs.

We start with storage because we already cleaned that up in May 2023: 

Add sheathing


Add some Tyvek:


Put trim on corners and start shingling:



(We ran out of nails, hence partial progress.)






Garage Door #4

We're almost done with the front of garage, here's the latest.

Finish door trim on both sides and corners.


Begin shingling the entire field.


Add some decor at gable end to match the house:


And voila, nearly done:


Garage Door #3

 Gotta keep garage door progress moving ahead...

First add sheathing:


Then follow with some Tyvek to prevent water/wind inflitration:


Add PVC trim on sides of door opening:


Add PVC trim on top of door with z flashing:



Garage Door #2

This is a little lather, rinse, repeat from our previous post. But the termite damage on the left front corner was pretty exceptional. From afar the left corner doesn't look too bad


Upon closer inspection, the termites bored from ground up to the top plate, almost 10' off the ground.


So we support the corner with a temporary column and begin to demo the entire corner post.


We reframe the corner from ground to the top plate:


Install king studs on each side and add a header.  How does one install a header by themselves?

And voila, we have two properly installed garage headers.



Garage, other side, part deux

We don't have a ton of pictures even though good progress was made.   Short story: we finished all the termite damage replacement, simil...