Snowblower sidetrip

You may recall that I rebuilt the snowblower this summer. And that went well.  I got things running, reassembled and ready.  And after a few months found this on garage floor:


Yeah, that's a leak. Turns out to be gear lubricant from the gear case, one of the few things I do NOT rebuild over the summer, so I guess I have a new project.

Time to take snowblower auger off:


Remove auger from housing:


And let's take it apart to see if there's a seal that can be replaced:


So take things apart, clean them out and order replacement lube and seals for gear box.


Oh? And see the green seal on the shaft below? That I can't replace because the impeller is completely rusted to the drive shaft.  I tried using penetrating oil and propane torch to heat impeller but that proved useless - the rust has fused these together.


Update: fully assembled and working, but I won't share how many times it took to get the driveshaft and augers assembled correctly (hint: neither the driveshaft nor augers are symmetric so there are many wrong ways to assemble them).




No comments:

Post a Comment

Garage, other side, part deux

We don't have a ton of pictures even though good progress was made.   Short story: we finished all the termite damage replacement, simil...