Slider wall

Today was mostly about getting sliding door exterior wall setup for shingles.

Started by stripping shingles.


After examination, lot of water damage for lower right corner - both sheathing and studs have lots of rot.


Decide to cut out lower 4" or so to remove all the rot.


Add three pressure treated 2x4s to fill void from rotted studs.


Get sheathing up.


Apply Tyvek, caulk slider frame and screw it in, then apply final water seal tape over slider flange. This is water tight.



No comments:

Post a Comment

Garage, other side, part deux

We don't have a ton of pictures even though good progress was made.   Short story: we finished all the termite damage replacement, simil...