Basement and more... basement

One of the challenges we face is dust in the house, all over the place. And we are using reasonable dust collection measures (eg: vacuum when sanding, etc). Part of the problem is all the work in basement and both cats and humans tracking sawdust up into the house.

Part of the challenge in the basement is the floor - it's not level and it's pretty rough - so simple tasks (like sweeping) are challenging.  We finally decided it was time to improve that by applying self-leveling underlayment - this will both level the floor as well as give us a smooth finish, making it easy to clean.

Start by lugging thirty 50lb bags of self-leveling underlayment to basement.


Then apply concrete cleaner/degreaser which also etches the surface so the new concrete underlayment will bond.



 However the cleaner needs to be rinsed and removed, so we have to shop-vac all the rinse water up.

Let concrete dry overnight, and then apply a concrete primer to help new surface bond to old.


'
Let primer dry for approx 2 hours.  We're only pouring 1/4 of the floor at a time, so use expanding foam to make a dam and isolate self-leveler to certain areas.  


Here we go. Not a lot of pictures during mixing - once you start, the product only has about 15-30 minutes of working time, so you gotta keep moving quickly.  Mix, pour. Mix, pour.


This small section by stairs took 4 bags.


This larger section (that wraps under stairs) took 8 bags - I should've only used 7, but it's close enough.

The self-leveler dries completely in about 2-3 hours.  Once dry we scrape off the foam insulation and just pour next section up to the previous pour and *voila*..

No comments:

Post a Comment

Garage, other side, part deux

We don't have a ton of pictures even though good progress was made.   Short story: we finished all the termite damage replacement, simil...