Buttoning up a ceiling

Spent most of the day cleaning up bathroom from spray foam insulation and getting ready for drywall.

Had to pull down all plastic sheeting (and dripped foam insulation), seal any leftover small cracks and then install furring strips - this will lower the ceiling about 1/2" and make it easier to go over the spray foam.


Also pictured above, we packed the rest of cavities with old insulation batts that were previously removed from ceiling.  And marked the wall where furring strips are located to make screwing drywall easier.

And then we also installed leftover R13 fiberglass batts between the furring strips to make it clean and offer even more insulation.


And mostly finished - just drywall over batts and mud the corners.





No comments:

Post a Comment

Garage, other side, part deux

We don't have a ton of pictures even though good progress was made.   Short story: we finished all the termite damage replacement, simil...